AgsanSol

Hygiene product

AgsanSol

Setting the standard in waterline cleaning

  • Effervescent cleaner
  • Gentle on equipment
  • Environmentally friendly; dissolves in water and oxygen
  • Stabilized hydrogen peroxide
  • Optimizes effect of medication, vaccines and additives
More information or order this product?

Directions for use

Cleaning WITHOUT animals present

  1. Fill the system with 1-3%  AgsanSol™
    (10 – 30 gallon AgsanSol™ per 1000 gallon water)
  2. Ensure for adequate air release out of the system
  3. Open the end of the drinking system to check if AgsanSol™ is present
  4. Use peroxide strips or watch for a fizzling reaction on the barn surfaces
  5. Touch all nipples so AgsanSol™ can enter
  6. Keep AgsanSol™ in the system for 24 hours; customers have left AgsanSol™ in water lines up to 30 days
  7. Thoroughly flush system with fresh water
  8. Touch all nipples again to flush AgsanSol™ out of the system

Corrosivity

Several cleaning agents were tested and compared for corrosiveness on iron and zinc. The results below indicate the corrosiveness after a contact time of 72 hours measured in mg/l oxidation of iron and zinc.

 ZincIron
AgsanSol™99110
Hydrogen peroxide1100<2000
Hydrogen peroxide + peracetic acid21008800
Chlorine1200610

Packaging

  • 2.6 gallon
  • 15 gallon
  • 55 gallon
  • 260 gallon
"We have been using AgsanSol at 100 ppm for several months now, an regularly test ATP levels roughout our water system. The results have consistently remained below 10, with most readings around 4-5. Based on these measurements, we are satisfied with the hygiene status of our water lines and the consistency of the water treatment program."
Joost Teunissen
Creek Side Ranch, California